Service manual

Min.
Max.
D - MACHINE ADJUSTMENT
Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
The cutting pressure to be adjusted whenchanging the cutting knives or the sewn workpiece. Turn the screw
10
clockwise to increase the pressure. The adjusted pressure must be as small as possible.
NOTE:
To nd out, whether the cut is even, press the lever by hands onto the paper. The imprint must be even along the
whole length. We do not recommend repairing damaged knives. Use a ne sandpaper or a grinding machine to clean
the surface of the cutting steels that are worn out. Any grooves on the cutting steel can cause improper cut of fabric
or can damage the cutting knife.
WARNING:
Danger of fast wear-out of the knife or even destruction of mechanism parts. When changing the knife or the cutting
steel, recommend decreasing the pressure of at least three revolutions by the screw
10
and increase progressively.
It is necessary to check the cleanness of the cut. The pressure must not be too big that the drive belt slips.
S-101.M
1-42