Service manual

X
53,5 mm
49,5-0,3 mm
Y
Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
D - MACHINE ADJUSTMENT
13. MATERIAL CUTTING MECHANISM ADJUSTMENT
The adjustable mechanism
7
at this type of machine has the cutting steel tted into the cutting lever
1
and the
cutting knife tted into the cutting block. The starting point for the adjustment of the cuting mechanism is the needle
mechanism and sewing mechanism. The cutting lever
1
is tted onto the studs
2
and secured with the screw
3
.
The axial play adjust care fully by bringing the studs near/away and secure them in the position, when the cutting
lever has minimum play.
13.1. Adjust the knife in Y-axis using the stop
6
; in X-axis after loosing the screw
5
: to the left ← A or → B to the
right .
S-101.M
1-41