Service manual

0,10...0,20
B
0 2 ,3 m, -0 m
Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
D - MACHINE ADJUSTMENT
2.3. Turn the hand wheel
1
to keep the stop
14
at the lever
11
in A position. Turn the left wheel
13
until the stop
14
of the right stopping wheel gets released. Once the stop is realesed, stop turning!
2.4. The play of 0,1 ...0,2 mm between the dogs
14
can be adjusted by loosing the screw
15
, moving the wheel
16
inside or outside as necessary. Tighten the screw
15
after the adjustment.
2.5. Turn the hand wheel
1
until the stop gets into B position. Turn the left wheel
13
to the point where the roll
2
reaches the highest point of the draw bar
3
, which is the furthest movement backwards that the stopping lever
11
can make. Adjust the play 0.2-0.3mm point between the block
17
and the lever
18
, once you loosen the nut
19
.
2.6. Further wheel
13
movement makes the roll
2
leave the highest point
3
. At this point, release the lever
18
that
is tted onto the block
17
. The brake
9
is in contact with the cam
10
when turning the hand wheel
1
. The paly
between the dogs
14
should be cca 0,25mm or more at the end of the sewing cycle. If it is not, loosen the screw
20
in the travel at the left side of the machine and adjust it as necessary. (Towards the operator shaller play, from the
bigger play). Test the cycle.
S-101.M
1-29