Service manual

A B
A
B
B
A
Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
C - CORRECT USAGE
9. CHANGING THE POSITION OF STITCH ROW – GAPS FOR CUT
The change of the position of stitch rows is used especially when the thickness of the sewn material changes or when
the machine is adjusted from cut before to cut after and vise versa.
After loosing the nut
1
, you can change the setting by rotating the excentric pin according to the drawing. By moving
it towards the operator the cutting space is extended, by moving away from the operator it is reduced. Tighten the nut
1
securely afterwards.
WARNING!
When you change the gap between both rows of stitches, you may need to adjust the sewing mechanism as well. It
is also necessary to check, if the needle is not hitting the edge of the stitching plate so that the needle will not brake.
10. SETTING THE SPREAD OF THE CLAMP FEET
Different types of material require larger or smaller spread of the material between the clamp feet. In order to change
the spread, use the setting shown in the picture.
Loosen the screw
1
at each side of the machine and move the setting stops
2
inward → A, to make the spread
wider - and outward → B, to make the spread narrower.
NOTE!
Make sure that the spread is equal on both sides.
S-101.M
1-25