Service manual

A B
P
D
C
L
L
B
A
B
A
C - CORRECT USAGE
Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
8. STITCHING LENGTH AND FLYBAR ADJUSTMENT
8.1. The length of stitching, it means the moment when the sewing process begins with the movement of working
desk can be inuenced as follows: loosen the screw
4
of the dial gauge
5
and move it
5
so that the required length
of stitching on the dial gauge
5
is at the same point as the edge of the mark
2
.
Tighten the screw
4
. The total length of stitching L is now set up – see the picture.
WARNING!
The total length of stitching is the length of cut + the length of seaming.
8.2. If a buttonhole with ybar is to be sewn, it is necessary to loosen the screw
1
of the ruler
3
, move the ruler
3
towards the operator (to obtain longer ybar) or off the operator (to shorten ybar, or eliminate it). This is the tech-
nique to adjust the P length – see the picture.
WARNING!
If you adjust the length, you must install a cutting steel of the corresponding length.
S-101.M
1-24