Service manual

C - CORRECT USAGE
Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
1. BUTTONHOLE SEWING PROCESS
1.1. Read carefully all safety instructions and make sure all covers are mantled onto the machine.
1.2. Put lubrication oil into lubrication holes marked as „oil“, check that theke a right amount of oil in the oil reservoir
with oil gauge (see section E3).
1.3. Check, whether the upper thread and gimp are threaded correctly, as in Section C3.
1.4. Before starting the machine for the rst time, put a small piece of fabric, similar to your piece to be sewn, under
the clamps.
1.5. Plug the power cord into the socket and start the motor with the operation switch (circuit breaker)
1
.
1.6. Press the foot pedal
2
to activate the machine drive. Make sure that the drive pulley under the rear tilt cover
moves clockwise.
WARNING!
To make certain that the machine sews correctly, we recommend sewing a few buttonholes on a scrap piece of fabric.
It will also remove excess oil from the sewing area. When the machine is in the operation, do not try to hold or move
the sewn fabric with your hands.
1.7. Place the fabric under the clamp feet.
1.8. Moving the lever for manual clamping
3
towards the operator will bring the clamping feet
8
down and they will
clamp the fabric.
1.9. Press the start up lever
4
. The clamping feet go down automatically. Once the sewing is nished and button-
hole cut, the clamping feet go up.
1.10. If it is necessary to interrupt the sewing during the cycle, pull the stop lever
6
. The machine nishes the cycle
without sewing and the clamps go up.
1.11. You can stop the machine at any moment during the cycle with the foot pedal
2
(pressing the pedal by your
tiptoe stops the sewing, pressing the pedal with your heel starts the sewing again).
1.12. To start the cycle witmout sewing, it is necessary to lift the supporting lever
7
and once youturn the machieon,
the machine nishes the cycle without sewing.
S-101.M
1-16