Service manual

Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
B - MACHINE INSTALLATION
5. BELT ASSEMBLY AND ADJUSTMENT
An appropriate Jackshaft Ass. pulley
8
shall be used according to the mains power system (line power) frequency
– either 50 Hz or 60 Hz.
WARNING!
The machine can be seriously damaged when operated at higher frequency than recommended by the machine
supplier (AMF Reece).
5.1 Remove the belt cover
1
and loose the nut
2
. Tense the timing belt
4
by skewing the motor
3
. Tighten the nut
2
afterwards.
5.2 By loosing the screws on gearbox
5
adjust the timing belt
6
tension. Then, tighten the screws again.
5.3 Install the leather belts onto pulleys (the right belt from Jackshaft Ass. to the hand-wheel pulley, the left belt
7
crossed to the fast-feed pulley). Consequently, adjust the connecting-rod between motor and pedal. Check correct
direction of pulley rotation. Install the pulley cover.
WARNING!
Too loose leather belts can cause machine stopping during material cutting.
1-15
S-101.M