Service manual

e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
Revised 09/2004
S-101
1-11
CONTENTS
SHEET NO.
INSTRUCTION FOR INSTALLATION ON REECE INDIVIDUAL TABLES ............ 1-1
STOP MOTION ADJUSTMENTS ................................................................................... 1-2
MODEL 101 - SETTING UP INSTRUCTIONS.............................................................. 1-3
THREADING DIAGRAMS .............................................................................................. 1-4
MODEL 101 - OPERATING INSTRUCTIONS ............................................................... 1-7
ADJUSTMENTS THAT DETERMINE THE CHARACTER OF THE BUTTONHOLE
Needle information ...............................................................................................1-8
Adjusting the bite and cutting space....................................................................1-9
To adjuste the clamp spread ................................................................................. 1-9
Adjusting the number of stitches per inch in a buttonhole ................................ 1-10
Increasing or decreasing of number of stitches in the eye independently
of the sides ............................................................................................................. 1-10
Tension ................................................................................................................... 1-10
MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE
Needle bar and race line up adjustment............................................................... 1-11
Equalizing the loopers .......................................................................................... 1-12
Looper and spreader adjustment .......................................................................... 1-13
To adjust play in split collar yoke ........................................................................ 1-14
To line up and adjust the cutting lever.................................................................1-14
Adjusting the clamp operating mechanism .........................................................1-15
To adjust the trip lever .......................................................................................... 1-16
To correct distortion of eye...................................................................................1-16
To adjust the roll pressure on length gauge.........................................................1-16
To adjust the rocker arm and stop motion ...........................................................1-17
Adjusting the stop latch on stitching wheel ........................................................1-18
Adjusting the trigger setting mechanism ............................................................. 1-18
To adjust the timing of the L.H. handwheel in relation to rocker shaft and
lever........................................................................................................................1-18
To adjust L.H. handwheel to disengage at the stopping position
of the machine .......................................................................................................1-19
To adjust for friction on worm shaft .................................................................... 1-19
To adjust for friction on main shaft ..................................................................... 1-19