Service manual

e-mail: [e-mail]; [e-mail] ; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
Revised 09/2004
S-101
1-5
UPPER SYSTEM
Thread is
between
tension discs
Long groove
Detail
Use T-20 thrading wire for
threading needle bar
Detail
Spread washer so that
thread will rest in notch
THREADING OF FIXED TYPE TENSIONS
Split disc type Solid roller type
To needle bar
To needle bar
From thread
supply
From thread
supply
Note: Thread makes approximately one full turn
around the roller on this tension.
THREADING OF ROCKING TYPE TENSIONS
Split disc type Solid roller type
To needle bar
To needle bar
From thread
supply
From thread
supply
Note: Thread makes approximately 1 1/2 turns
around the roller on this tension.
Note: Refer to sheet 23 for additional information on threading Cord Trim Machines.
THREADING DIAGRAMS