Service manual

1-2
S100
Revised 10/2005
e-mail: [e-mail] ; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
A - INTRODUCTION
2. SPECIFICATIONS
Machine Type S100 - 030 S100 - 033 S100 - 035 S100 - 036 S100 - 060 S100 - 052 S100 - 053 Description
Eyelet buttonhole machine for sewing the
buttonholes with the cross bar and flybar
Buttonhole style Sewing speed 1450 ± 5% stitches/min
13-32 mm
Stitch Density Bite Range Cord Trim - - Eye Type 2.5; 3; 3.5; 4 3.5; 4; 5; 6; 7 Flybar Length Flybar Density Number of stitches in the eye Cross Bar Length 4 - 8 mm Cross Bar Density 6 - 16 stitches / cm Clamp Foot Height Maximum work thickness Buttonhole Cutting Mode Cutting Space * Recommended threads Operating Conditions Air Pressure - - Machine db Level Machine Head Dimension Machine Head Weight 66 kg Table Dimension Machine Weight 151 kg Electrical Requirements
1NPE~60Hz 110V/TN/S ; 3NPE~60Hz 230V/TN/S ; 1NPE~50Hz 230V/TN/S ; 3NPE~50Hz 400V/TN/S
8 - 16 stitches/cm
64 kg (143 lb) 64 kg (143 lb)
780 mm (31") - height x 1100 mm (43") - length x 600 mm (23.6") - width
149 kg 149 kg
standard cutting after (CA), possible setting cutting before (CB)
standard 0.5 - 0.7 (minimum 0.1; maximum 1.4) -
Buttonhole Length
10 - 38 mm (0.4 - 1.5") without upper thread trimming,
10 - 32 mm (0.4 - 1.26") with upper thread trimming
-
- -
-
- -
6-16 stitches /cm (15-41 stitches /inch)
without eye, 2.2 x 3.0 mm (0.086 x 0.118"); 3.2 x 5.0 mm (0.126 x 0.197")
max 6 mm (1/4")
600 mm (23.6") - height x 465 mm (18") - length x 530 mm (21") - width
02.0501.0.111 (1807 D Nm 100 - standard)
02.0503.3.113 (1807 D Nm 110-130 - thick fabric)
according to IEC 364-3, IEC 364-5-51 temperature from +5° to 40°C, relative air humidity from 30 to 80 %
from 75 to 81 dB at max. speed
5.6 bar (80 psi) -
Size 80,100,120
-
6 - 16 stitches / cm
10 mm (0.4")
standard 6 mm (possible range 3.0 - 7.0 mm)
Eyelet Buttonhole Machine
Eyelet buttonhole machine for sewing
the regular eye buttonholes
Needle system
1768 ± 5% stitches/min 1768 ± 5% stitches/min
2 - 4 mm
yes -
8
8
8
* Note: If a customer uses thread size 100 and less, the manufacturer recommends to use the left looper 17.0069.4.019