Service manual

1-62
S100
Revised 10/2005
e-mail: [e-mail] ; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
F - MACHINE ADJUSTMENT - CROSS BAR
4. DEVICE FOR SEWING THE CROSS BAR
The mechanisms for sewing the cross bar adjustment
1. Remove the side cover and tilt the rear cover.
2. Loosen the nut  and using the screw  adjust the lever , to obtain the clearance 1.5 mm
between the lever  and the cam .
3. Using the hand crank move the table to the rearward position from the operator. The lever  in this
position, must be lifted, so that the pawl  falls behind the top of the lever drive  in direction to
the operator. The clearance 0.5 - 1 mm should be maintained between the pawl  and the top of the
lever .
4. The lifting of the lever  is ensured by jack . After loosening the nut , it is possible to change
the position of the jack  by screw . When the lever  pressed, keep the clearance 1 mm.