Service manual

S100
1-51
Revised 10/2005
e-mail: [e-mail] ; [e-mail] ; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
D - MACHINE ADJUSTMENT
Stop
7. Then position a piece of fabric between the knife and the cutting steel and cycle the machine and
check the cut of the fabric. The cut must be even and can not be discontented through the whole
length. If is it incorrect, rotate the pressure adjusting screw  one revolution clockwise only, cycle
the machine and check the cut. Increase the adjusting screw pressure one revolution at a time until a
correct cut is obtained.

















