Service manual

S100
1-47
Revised 10/2005
e-mail: [e-mail] ; [e-mail] ; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
D - MACHINE ADJUSTMENT
Rotate the right-handwheel until the needle bar reaches the lowest point of the vibrator stroke. After raising
the needle bar 3.5 mm, (0.140"), note the position of the right  looper point to the center line of the
needle.
If the looper point is not to the center line of the needle, loosen the clip screw and move the right-hand
looper half the distance to the needle center line, by this you align the distance of both loopers.
Tighten the screw.
Total distance is 4 mm - move the end of the looper toward
the center of the needle 2 mm (0.079”)
CAUTION! Check both needle bar strokes to ensure both sides are equal distance from the point of
the looper to the needle centerline.
Example:
4 mm
2 mm


