Service manual

S100
1-25
Revised 10/2005
e-mail: [e-mail] ; [e-mail] ; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
htgneL
EYETUOHTIWSELOHNOTTUBROF
EYEHTIWSELOHNOTTUBROF
epahs/eye030.epytmacepahs/eye030.epytmac530.epytmac
04-310 101.4.7600.715/3201.4.7600.71
230 5
41.4.7600.715/3161.4.7600.71
920 441.4.7600.715/3061.4.7600.71
620 341.4.7600.715/3951.4.7600.71
420 241.4.7600.715/3851.
4.7600.71
220 141.4.7600.715/3751.4.7600.71601.4.7600.71
020 041.4.7600.715/3651.4.7600.71
910 931.4.7600.715/3551.4.760
0.71501.4.7600.71
810 831.4.7600.715/3451.4.7600.71
610 731.4.7600.715/3351.4.7600.71301.4.7600.71
61
* 5/3
304.4.7600.
71
410 631.4.7600.715/3251.4.7600.71
310 531.4.7600.715/3151.4.7600.71
210 431.4.7600.715/3051.4.7600.71
010 331.4.7600.71
2
3-31**0 504.4.7600.715/3404.4.7600.71
D - MACHNE ADJUSTMENT
Supplied lateral cams:
* Only for order: flybar 7 mm, stitch width 2 mm
** Only for CRB
WARNING !When the lateral cam is changed, it is necessary to ensure the adjustment of the
correct buttonhole length, and install the correct cutting steel or knife.
6. CHANGE OF THE WIDTH BITE
Can be use for all machine modifications.
To adjust the width bite turn the button  clockwise the width bite will decrease - see 1.
By turning the button  counter clockwise, the width bite will increase - see 2.
The standard width bite is in range from 2,8 to 3,4 mm (0.110” to 0.134”) it is adjusted by the manufac-
turer.
To change the width bite adjusted by manufacturer, follow this steps:
1. Loosen the screw from the button  and remove the adjustable button .
2. Remove the screw , the cover  and also the adjustable screw of the width bite  .
3. Rotate with adjustable segment  until the hole determining the width bite is not obtained.
4. Install the adjustable screw  and mount removed parts.
WARNING ! When the width bite is changed, it is necessary to adjust the loopers.