Service manual

S100

1-19

Revised 10/2005

e-mail: service@amfreece.cz ; parts@amfreece.cz ; website: www.amfreece.com

Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

D - MACHINE ADJUSTMENT

1. STITCHES DENSITY ADJUSTMENT - STRAIGHT SECTION

a) machine modification S 100 - 030/033/035/036/052/053

1. Remove auxiliary rear cover.

2. Loosen the stud nut .

3. Shift the rod stud  in direction 1 to increase the stitch density, in direction 2 to decrease stitch

density.

4. Tighten the nut .

Note: The limiter  is installed on the lever  . To obtain the stitch density 8-9 stitches/cm, shift the rod

stud  towards the limiter. To decrease the density, remove the limiter .



b) machine modification S 100 - 060

1. Fold the rear cover.

2. Start to sew the buttonhole, and stop the

machine at the moment, when the lever  is

shored up to screw .

3. Loosen the nut  and shift the lever  in the

slot. To decrease the density move the lever up,

to increase the density move the lever down.

4. Tighten the nut .











