Service manual

1-4
S100
Revised 10/2005
e-mail: [e-mail] ; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
A - INTRODUCTION
4. INSTRUCTIONS FOR THE SECURITY OF THE OPERATOR AND
MAINTENANCE
When the machine is set to the working area, it is recommended to keep the minimal distance said in the
drawing.
DANGER!
- Before machine connection to the power make sure, whether all safety covers are mounted.
- If it is necessary to remove some safety covers, switch off the operating switch (circuit breaker) and
disconnect the machine by the fork of supply from the socket.
- Do not connect the machine to the power if some cover is removed.
WARNING!
- Remember the position of the operating switch (circuit breaker) so that is possible use it from the
arbitrary position.
- Make sure, whether supply of energy and its dimensioning and safeguarding allows permanent
supply of energy needed for dependable output of the machine.
- Do not forget to persuade yourself before fork connection to the socket whether both switches on
the machine are switched off.
- Check if the electrical cables are not damaged, so that be touch with uncovered conductor, can not
occur any injury.
- Check regularly if the safety covers are correctly mounted and whether they are not damaged.
- When the covers are demaged, repair or replace them immediately for the new ones.
- Do not switch the machine on without covers.
- Do not touch rotary shafts by hands.
- In any circumstance, do not put hands to the needle space.