Service manual

EBS - MARK II
2-2
CAUTION!
Check the main parts of the machine on a regular basis and use only parts of high qual-
ity. The manufacturer recommends to use the original parts AMF Reece, mainly needles,
parts of the needle bar, loaders.
1. INTRODUCTION
NOTE!
It is possible to change the needed adjustment of the machine according to the fabric
type and in this way you can compensate the wearing of the machine parts. It is not pos-
sible to adjust the mechanisms fixed with yellow during the warranty period without an
approval from the manufacturer.
Revised:05/2013
E-mail: [e-mail]; webside: www.amfreece.com
Phone: [phone]; Fax: [phone]
TROUBLESHOOTING
CAUTION!
Check the main parts of the machine on a regular basis and use only parts of high qual-
ity. The manufacturer recommends to use the original parts AMF Reece, mainly needles,
parts of the needle bar, loaders.
1. INTRODUCTION
NOTE!
It is possible to change the needed adjustment of the machine according to the fabric
type and in this way you can compensate the wearing of the machine parts. It is not pos-
sible to adjust the mechanisms fixed with yellow during the warranty period without an
approval from the manufacturer.
The electronic machine EBS MARK II signalizes the error messages when the machine fails
to work. If these messages are not displayed and the machine fails to work during the sewing
process, it is necessary to check the thread (if it was not damaged by the threading hook) and
the needle (if it is not damaged or bent) first. Remove the other signalized failures according
to the detailed description in the following section.