Service manual

EBS - MARK II
1-63
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
E - STANDARD MACHINE
11. ADJUSTING THE BUTTON FEEDER
Press the emergency stop button. The chuck is open, move it up manually. Turn the feeder
lever manually under the chuck and check the height above the pucker-pin. The recommended
clearance from the pucker-pin is 0.1...0.2 mm. If you need to adjust it, use the height adjustment
screw
in the loader shaft after you have loosened the securing screw . Move back the
lever manually to the basic position indicated by the sensor light. Release the emergency stop
button and turn off the servo
. Switch back to the main
screen.
Move to the button parameters screen. Put a button onto the feeder. By pressing the icon
for the first time the feeder with the button moves under the chuck and the chuck lowers
to the level of the button. By using the corrections adjust the angle position of
the feeder so as the button corresponds with the chuck in Y - axis. In the X axis, adjust the
position of the button holder on the lever: After you loose the screew
, by pressing the icon
the chuck presses/ releases the button and centralizes the holder.
Now tighten the screw and press icon
for the second time. The button is caught by the
chuck and the loader moves to its basic position. Pressing the icon
on the main screen
releases the button.