Service manual

EBS - MARK II
1-37
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
D - MACHINE CONTROLS
3.2. PROMPT CYCLE MODE
The prompt cycle mode is designed only for 2 different button programs from which you can
be selected the sewn button program by pressing or not-pressing the machine pedal before
sewing. Machine has memory of 20 different prompt cycle mode programs.
3.2.1. PROGRAMMING THE PROMPT CYCLE MODE
To enter the prompt cycle mode screen press icon
on the standard cycle mode screen.
Press icon
on the prompt cycle mode screen to enter numerical keyboard and select the
cycle mode program number within the range 1 to 20.
Under the selected cycle mode program, enter required button programs for position 1, see
point
and position 2, see point . Press required position, to enter numerical keyboard and
type particular number of button program (1-94), see chapter D 2.1. Note that the cycle mode
can work only with pre-programmed button programs.
Bring machine to the position ready for sewing (green light is on), see chapter C 5.
If you want to sew the button program selected in the position 1 (see point
), press the start
button without pressing the machine pedal.
If you want to sew the button program selected in the position 2 (see point
), press the
machine pedal to switch the machine to this program and keep the pedal pressed while
pressing the start button.
NOTE!
The currently sewn button program / position is highlighted in red - see point .
Icons under point are used for quick setting and adjustment of the parameters of the
currently sewn button and have the same functions as icons used on the main screen,
see chapter D 1.
While the machine is not in the position ready for sewing (green light is not on), the icons
and can be used for switching between the programs and quick checking of the
adjusted parameters.