Service manual

EBS - MARK II
1-32
D - MACHINE CONTROLS
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
2.4.2. SHANK BUTTON
For shank buttons you can set the following parameters:
a) Use icons
to set stitch spacing in fabric within range 0 - 6 mm. When 0 mm spacing is
set, stitches are sewn into one place.
b) Use icons
to set the number of button attaching stitches according to the definition in
section A 5. within range 1 - 14 stitches.
c) Use icons
to adjust the position of the needle from the shank eye during button attach-
ing.
d) Use icons
to adjust the vertical position of button chuck during button feeding - this set-
ting depends on height of the button.
Icons in section
only appear if password level II is submitted (refer to chapter E 1.2.1.).
These icons have the same meaning as for the buttons with holes - refer to chapter 2.4.1.
Press icon
to shift to the second button parameters screen. You can set the following
parameter:
Use icons
to adjust the button position during entire sewing. This setting can be used to
achieve an optimal position of the button against the fabric.