Service manual

EBS - MARK II
1-31
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
D - MACHINE CONTROLS
2.4.1. 2, 3, 4 - HOLE BUTTONS
For buttons with holes you can set the following parameters:
a) Use icons
to set the holes spacing in X-axis and icon in Y-axis. Refer to picture for
a detailed explanation of X-and Y-direction, when the button is placed on the button holder.
The hole spacing range is 2.6 - 6 mm.
b) Use icons
to set the number of button attaching stitches according to definition in chap-
ter A5 within range 1-14 stitches.
c) Use icons
to adjust the vertical position of button chuck during button feeding - this set-
ting depends on height of the button.
Icons in section
only appear if password level II is submitted (refer to chapter E 1.2.1.).
These icons help in setting the right chuck position
and exchange of the button holder
(refer to chapter A 9). The following functions are available:
1. By pressing icon
, one half of button feeding cycle is performed.
2. By pressing icon the button chuck is opened / closed.
3. Use icon to open / close the fabric holder.
Press icon to shift to the second button parameters screen. You can set the following
parameters:
a) Use icons
to adjust the button position during button attaching. The higher the button is
during attaching, the looser the thread remains - consequently, the fabric is less disturbed
after the neck wrapping.
b) Use icons
to adjust the button position during neck wrapping. This setting can be used
to achieve an optimal position of the button against the fabric.