Service manual

EBS - MARK II
1-30
D - MACHINE CONTROLS
Released:01/2013
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
2.4. BUTTON PARAMETERS
2.3. BUTTON STYLE
Press icon
on the main screen to enter button style screen. You can set the following pa-
rameters:
a) Press one of the icons under point
to select required button style.
b) When sewing 3, 4-hole or shank button it is necessary to select the stitching method by
icons
or . Press icon to select overlapping stitching method (machine first sews
all stitches on the left pair of holes and then all stitches on the right pair of holes). Press
icon
to select alternating stitching method (machine alternately sews right and left pair
of holes).
Press icon
to enter button parameter screen to program additional parameters of the
selected button. For further explanation refer to chapter D 2.4.1. for 2, 3, 4 - hole button and
D 2.4.2. for shank button.
After selecting the required button style (see chapter D 2.3.) continue with button parameter
settings.
Press icon
on the button style screen to enter the first button parameters screen; alternatively,
you can go directly from the main screen by pressing the icon .