Service manual

EBS - MARK II
1-28
D - MACHINE CONTROLS
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
2. BUTTON PROGRAM SETTING
2.1. BUTTON PROGRAM
NOTE!
Before setting any button parameters described in sections D 2.2.-2.9.
- a button program has to be selected
- password level II has to be entered - refer to chapter E 1.2.
The machine has 99 different button programs. Programs 1 to 94 are available and can be
programmed by operator. Programs 95 to 99 are default factory settings and can not be
changed.
To set new button program, press icon
on the main screen to enter numerical keyboard.
Type the required program number within range 1 to 94. The typed number appears on the top
of the numerical keyboard screen, see point
. Save the setting and return to main screen
by pressing icon .
Once the button program is selected, start programming the button parameters according
to chapter D 2.2. -2.9. All set button parameters are automatically saved under the selected
button program.
When you need to return to an already programmed button program, follow the same steps for
setting a button program as described above.
NOTE!
Alternatively, you can use the following method: