Service manual

EBS - MARK II
Released:01/2013
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
C - CORRECT USAGE
1-23
5. BUTTON SEWING PROCEDURE
5.1. Set the machine to its basic position for sewing according to
chapter C1 of this part and check that the needle is in the up-
per needle bar.
WARNING!
Check the display parameters are in accordance to the chosen
button.
5.2. Put the button on the appropriate hold-
er
. Press the foot pedal so as the
button is automatically loaded into the
chuck under the needle bar.
5.3. Place the sewn piece on the tongue
. The cross of the marking light must overlap the
sign marking correct position of the button on the sewed piece. The piece must be evenly
aligned and must freely encircle the tongue.
5.4. Push the tongue into the machine up to the place where the machine fastens the piece.
Carry out a second check of the piece surface evenness.
5.5. Press the foot pedal so as the machine press the sewed piece by the auxilary holder
;
at the same time, the necessary thread end is blown for threading.
5.6. Thread according to chapter C3.
5.7. The thread must lie freely on the sewed piece. From now on it is possible to put the sec-
ond button into the holder.
5.8. Before sewing, you can quickly enable/disable sewing of the show stitch by pressing the
foot pedal - this is signalized on the screen.
5.9. Press the button
and hold it for approximately 0.5 sec. until the thread is loaded. The
machine sews the button and trims the thread - the next button is loaded into the chuck
if automatic button feeding
is activated on the machine parameters screen.
NOTE!
Trimming can be disabled by holding the button during the time of trimming.
Automatic button feeding can be disabled by hoolding the foot pedal.