Service manual

EBS - MARK II
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
C - CORRECT USAGE
1-19
Right position is established once the button
doesn´t move while being caught by the chuck.
In that case finish the button feeding cycle by
second pressing of the icon
.
4.1.4. Press the tongue
(without a fabric) up
to the position where it is hold automati-
cally. Press the machine pedal – the auxil-
iary fabric holder
will go down. Together
with this action, the thread is blown into the
sewing area. Do not thread the thread at
this time.
NOTE!
Automatic activation of the fabric holder can be enabled in the machine parameters
screen - refer to chapter E 1.5.
4.1.5. Go to the Jogging screen and activate jogging by pressing
- refer to chapter E
1.6. for details on jogging of the button sewing, which shall be studied before proceed-
ing to the next steps in this chapter.
4.2. ADJUSTMENT OF BUTTONS WITH HOLES
4.2.1. Measure the spacing of button holes in X and Y direction and enter it by using icons
and respectively on Button Parameters screen. Mostly, the same
value will be measured for spacing in X and Y direction.
4.2.2. Machine is in the beginning of Jogging mode and “Begin Lock 1/5”(for 2 initial lock-
ing stitches as an example) is displayed in the Current sewing phase field of the Jog-
ging screen. First initial locking stitch is being sewn and position of the stitch depth can
be adjusted by icons
in standard case or if all show stitches option
has been selected on the Stitch Style adjustment screen.
4.2.3. Button attaching phase starts right after the initial locking stitches and “Button” is dis-
played in the Current sewing phase field. In this phase adjust the button holes Spacing
by icons
and on the Button Parameters screen so that the needle
goes into the center of all buttonholes.