Service manual

EBS - MARK II
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
C - CORRECT USAGE
1-17
3. THREADING
3.1. Lead the thread from the stand according to the pictures below and insert it into the tube
up to the bottom end of the tube. By pressing activate the air threading system
and the thread
is led close to
the needle.
3.2. Activate the symbol of threading
on the main screen. The thread gets in the area
of the needle.
3.3. After loading the fabric (refer to chapter C5), the threading hook
is in the needle. Lead
the thread under the threading hook .
3.4. The threading into the needle is carried out automatically if you step on the foot pedal.
The operator pulls out the the lenght of the thread necessary for one sewing cycle.
NOTE!
The thread lenght is dependent on the chosen programme - the chosen type of button, the
number of stitches, the neck height and the number of neck wrappings affect it.
If the hook damages the thread, it is necessary to cut off the damaged thread in the place
where it was damaged.