Service manual

EBS - MARK II
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
C - CORRECT USAGE
1-15
1. TURNING ON THE MACHINE - ESTABLISHMENT OF HOME POSITION
NOTE!
Refer to section D for the comprehensive description of machine control through its
display.
1.1. Before the first machine startup it is necessary to remove the preserving oil and grease
all respective places as stated in chapter F 3.
1.2. After plugging the machine cord, switch
of the upper transformer on the electro-box
can be used to light the sewing area by LED light. Switch Ï of the lower transformer
serves for lighting up the positioning cross
.
1.3. Turn on the machine by rotating the main switch clockwise to position I ON.
1.4. Display is activated and backlit. Initial screen appears, wait for appearing the main
screen
.
1.5. If error notification E02 appears
in field
, machine drive is not
in home position. Rotate the
hand-wheel until E01 appears
in field
. Then press the but-
ton
. In case of another error
notification proceed according to
instructions in section 3 "Trou-
bleshooting" of this manual.
1.6. Machine is ready for sewing
when there is a green label in
field
. (For display descrip-
tion refer to D 1).