Service manual

1-13
U1
U2
J1A/B-J13A/B
U3
U5
U4
U6
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
B - MACHINE INSTALLATION
EBS - MARK II
5. CONNECTING THE MACHINE HEAD WITH THE CONTROL CABINET
The machine is delivered from the manufacturer as completely engaged. The control cabinet
of the base includes the electronics necessary for controlling the machine , attached unit
for the modification of compressed air , and the valves used to control the pneumatic
cylinders of individual mechanisms.
In case of eventual demounting and mounting, the following should be joined:
- blue pneumatic hoses J1A/B — J13A/B with electromagnetic valves of the same desig-
nation - hoses A to the upper screws, B into the lower screws
- two cables into of the servomotor - encoder/power
- the cable harnesses of stepping motors with cables of the same designation from
the cabinet in corresponding supports U1... U6
- connecting the LED sewing light + the marking light to the transformers on the cabinet
- the sensor cables BQ 1...BQ 12 connected (see ) to the terminal under the table