Service manual

EBS - MARK II
1-9Released:01/2013
E-mail: [e-mail]; webside: www.amfreece.com
Phone: [phone]; Fax: [phone]
A - INTRODUCTION
9. BASIC INFORMATION ABOUT THE MACHINE
9.1. EBS MARK II machine is intended for
sewing of two-, three-, four-hole, and
shank-buttons
to outwear garment us-
ing a hand-stitch imitation technology.
One can adjust the number of button
attaching stitches, button-hole stitches
sequencing, number of neck-wraps, and
number of initial and final locking stitches. Automatic thread trim-
ming feature is also available. All these operations are carried out in
a single sewing cycle. Chapter A6 - Technical Conditions refers the
threads recommended for the machine.
9.2. There are two sewing styles:
a) standard sewing style
b) “V” -shape sewing style - “V” -shape sewing style allows
very small distance of the stitches in fabric and subsequent reduced
puckering of the fabric.
9.3. Machine is delivered with replaceable button holders
, correspond-
ing pucker-pins , and tongues – refer to Table A (next page).
Flexible, automatically adjustable pins of the button holder allow one
loader to comprehend various button sizes; thus it is not necessary
to change the holder with each change of the button size as usually.
Two types of button-chuck , covering a wide range of applications,
are also contained as standard accessory.
9.4. Machine stand (chapter B2) allows adjusting the height of the table
with a safe fixing of the position.
9.5. Machine on the stand can be moved and fit in place because of the
wheels with adjusting screws – refer to B2. Lower-level desk can be
adjusted in horizontal direction according to the operator’s needs.
9.6. Button loader, pucker-pin, and tongue shall be selected based on the
description given in table A.
9.7. Machine can be ordered in the following two configurations:
a) 5-threads
b) 5-threads, “V”-shape
5-threads threading system is mainly suitable for unit production, where the thread is
changed often. The system enables quick exchange of threads.
9.8. Thread draw-off is intended for better unwinding of the thread from a bobbin. It is mainly
convenient for threads with recovery or wax-threads.
9.9. Workspace is illuminated with LED-lights.
9.10. The machine complies with the CE standard.