Service manual

SERVICE AND REPAIR
• Disconnect brake cable and housing at brake
mounting bracket and at brake actuating lever.
• Remove the two bolts and lockwashers securing
the mounting bracket to the driven clutch mounting.
• Remove the brake assembly.
• Installation procedures are the reverse of re-
moval. Refer to Brake Adjustment procedures.
Brake Adjustment
• To adjust the brake pads (5, figure 7) to the disk
(1), remove the cotter pin (2) and tighten or loosen
the castle nut (4) as required to permit the brake
pads (5) to just clear the brake disk. Reinstall the
cotter pin. To adjust for excessive play in brake
cable or lever position, loosen jam nuts (6). and
move
brake housing (3) as required. Tighten jam
nuts.
Figure 7
To Remove Carburetor
• Loosen the throttle and if used, the choke control
cable adjustment screws and release both cables at
the carburetor (see figure 8).
• Remove the screws securing the air intake filter
or baffle (figure 9) and choke control bracket
mounted on carburetor used on Models SDI5PI0B,
SD18E20B and SD18E25B only.
• Remove the impulse line at the carburetor used
on all models except SDI5PI0B.
10
• Release the tank-to-carburetor gas line (figure
8). Wipe up any spilled gasoline immediately. NOTE:
On all Mark V series Ski-Daddlers, release the
carburetor-to-tank reCirculating gas line at the re-
Circulation elbow. Be certain to note the position of
the gas lines to insure proper reassembly. Wipe up
any
spilled gasoline immediately.
Figure 8
IMPORTANT: Model SD15PI0B uses a fuel pump
attached to the inside surface of the console tongue
with two
screws and nuts. If necessary to replace
the fuel pump, be certain to note the position of the
fuel lines to insure proper reassembly. Wipe up
any
spilled gasoline immediately.
Figure 9
1002472
o