Service manual

ManualsBrandsAMF ManualsSnowmobilesMARK V SD1BE2DA

c

c

Always

disconnect

the

spark

plug

wires

before

working on the engine

or

drive

elements.

• Loosen the flexible tube

clamp

securing

the

flexible exhaust tube to the

muffler

and

release

the

tube.

NOTE: The

Mark

V Ski-Daddler

has

dual

exhaust

tubes

and

muffler.

• Loosen

the

bolt

and nut

securing

the

muffler

to

the mounting band

assembly.

Remove the

muffler.

•

Installation

procedures

are

the

reverse

of

removal.

To

Remove

Bogie

Wheel

Always

disconnect

the

spark

plug

wires

before

working on the engine

or

drive

elements.

•

Place

Ski-Daddler

on the kickstand.

• Remove

the

locknut (3,

figure

13)

securing

the

bogie wheel

assembly

(2)

to the axle

shaft

and

re-

move the wheel.

• During

reassembly,

torque

the

locknut

(3)

to

28

foot-pounds. Be

certain

the wheel

assembly

(2)

is

installed

with

grease

fittings on the outside.

Figure

13

13

VICE

AND

REPAIR

To

Remove

Bogie

Wheel

and

Support

Assembly

Always

disconnect

the

sparkplugwires

before

working on the engine

or

drive

elements.

•

Place

the

Ski-Daddler

on the kickstand.

• Remove the

screws

(1,

figure

13) and

washers

securing

the bogie wheel

support

shaft

to the

main

frame.

• Remove the bogie wheel and

support

assembly.

•

Reassembly

is

the

reverse

of

removal.

To

Remove Bogie

Wheel

Torsion

Springs

• Remove

the

bogies

as

described

in

paragraph

To

Remove Bogie Wheel and Support

Assembly.

• Remove the

support

shaft

and

separate

the bogie

wheel

support

halves.

• Remove the

torsion

springs.

NOTE: The

torsion

springs

are

identified

as

right-

and

left-hand

springs.

Note the

direction

of the

coils

and

the

pOSition of the

springs

to

facilitate

re-

assembly.

•

Reassembly

is

the

reverse

of

removal.

To

Remove

Traction Belt Take-Up

Assembly

•

Place

Ski-Daddler

on the kickstand.

• Remove the

rear

bOgies.

Refer

to

paragraph

To

Remove Bogie Wheel and Support

Assembly.

•

Release

track

tension

by loosening

adjusting

bolts (5,

figure

13).

•

Release

the

support

arm

torsion

springs

con-

nected

to

the

main

frame.

• Remove the

right-

and

left-hand

adjusting

angle

locknuts (6),

washers

and

carriage

bolts

securing

the

traction

belt

take-up

assembly

to the

main

frame.

• Remove the

traction

belt

take-up

assembly

as

a

unit.