User manual

Released 06/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
DECO 2000
1-23
11.SWITCH OFF THE MACHINE
The machine can be stopped by the black STOP button at any time during sewing. Use this
button in case of possible injury or machine damage. The button is located on the left side of the
machine frame. The machine stops immediately when the Stop button is pressed. The error mes
sages appears on the screen.
Always remove the power supply to change the needle or make any other machine maintenance.
To sew again, press the green START button. The main menu appears on the screen.
Emergency stop:
CAUTION !
If the OK button is pressed on the error screen, the display screen appears
a) To continue the sewing cycle press the foot pedal. (Left foot pedal, if the machine is equiped with
two padals)
b) To start a new sewing cycle bring the needle up by pressing the UP button
Ë Ë
Ë Ë
Ë on the display
or by the right foot pedal. Press the left foot pedal to start sewing cycle from the beginning.
Standard stop:
CAUTION!
C MACHINE CONTROLS
OK
UP
SPEED 310
-
+
READY
STYLE STITCH 1
EDIT
500
150
UP
SPEED 310
-
+
ERROR
STANDARD STITCH
EDIT
500
150
Press the Error button and the error message screen appears on the display again . Press the green
START button.
The main menu appears on the screen. Then continue the procedure as in case a) or b).
1. Release the left foot pedal, and the machine will stop sewing.
Before turning off the machine make sure that the needle is up. If it is not in up position press the
UP button on the main screen or press the right foot pedal.
2. Press the black STOP button on the left side of the machine frame.
3. To switch off the machine turn the main switch to the off position 0.