Specifications

New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions 61
atmf provision New NNNNNYNYYYAMF
Commands
This command tells an AMF
port to expect that a new
node will be connected to it
later, and tells it the name of
the expected node. This
command needs to be run in
Interface Configuration
mode on master nodes only.
atmf provision
node clone
New NNNNNYNYYYAMF
Commands
This command is available
on master nodes only and is
part of setting up the files
that will download onto a
provisioned node. It allows a
customer to use another
node as a basis for the
provisioned one.
atmf provision
node configure
boot config
New NNNNNYNYYYAMF
Commands
This command is available
on master nodes only and
sets the configuration file to
use during the next boot
cycle. This command can
also set a backup
configuration file to use if
the main configuration file
cannot be accessed for an
AMF provisioned node.
atmf provision
node configure
boot system
New NNNNNYNYYYAMF
Commands
This command is available
on master nodes only and
sets the release file to use
during the next boot cycle.
This command can also set a
backup release file to use if
the main configuration file
cannot be accessed for an
ATMF provisioned node.
atmf provision
node create
New NNNNNYNYYYAMF
Commands
This command is available
on master nodes only and
creates a new directory for
use with a provisioned node
and is part of setting up the
files that will download.
Table 4: New and modified commands in 5.4.4-1.1
Command Status
x210 x230 x310 IX5 x510 x610 x900 SBx908 SBx8100 CFC400 SBx8100 CFC960
Software
Reference
Chapter
Description