Specifications

New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions 293
Installing this Software Version
Caution: Software version 5.4.4 requires a release license. Ensure that you load your
license certificate onto each switch before you upgrade. Contact your authorized
Allied Telesis support center to obtain a license. For details, see:
■ “Licensing this Software Version on an x210 Series, IX5-28GPX, x510 Series,
x610 Series, x900 Series or SBx908 Switch” on page 289 and
■ “Licensing this Software Version on a Control Card on an SBx8100 Series Switch” on
page 291.
To install and enable this software version, use the following steps:
1. Copy the software version file (.rel) onto your TFTP server.
2. If necessary, delete or move files to create space in the switch’s Flash memory for the
new file. To see the memory usage, use the command:
awplus# show file systems
To list files, use the command:
awplus# dir
To delete files, use the command:
awplus# del <filename>
You cannot delete the current boot file.
3. Copy the new release from your TFTP server onto the switch.
awplus# copy tftp flash
Follow the onscreen prompts to specify the server and file.
4. Move from Privileged Exec mode to Global Configuration mode, using:
awplus#configure terminal
Then set the switch to reboot with the new software version:
Return to Privileged Exec mode and check the boot settings, by using the commands:
awplus(config)#exit
awplus# show boot
Switch Command
x210 series
awplusawplus(config)# boot system x210-5.4.4-0.1.rel
IX5-28GPX
awplusawplus(config)# boot system IX5-5.4.4-0.1.rel
x510 series
awplusawplus(config)# boot system x510-5.4.4-0.1.rel
x610 series
awplusawplus(config)# boot system x610-5.4.4-0.1.rel
x900 series
awplusawplus(config)# boot system x900-5.4.4-0.1.rel
SBx908
awplusawplus(config)# boot system SBx908-5.4.4-
0.1.rel
SBx8100
with CFC400
awplusawplus(config)# boot system SBx81CFC400-5.4.4-
0.1.rel
SBx8100
with CFC960
awplusawplus(config)# boot system SBx81CFC960-5.4.4-
0.1.rel