Specifications

AMF Commands
224 New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions
show atmf detail
This command displays details about an AMF node. It can only be run on amf master
nodes.
Syntax show atmf [detail]
Mode Privileged Exec
Example 1 To display the AMF node1 information in detail, use the command:
A typical output screen from this command is shown below:
Parameter Description
detail Displays output in greater depth.
node1#
show atmf detail
node1#show atmf detail
ATMF Detail Information
Network Name : ATMF_NET
Node Name : Admin2
Node Address : Admin2.atmf
Node ID : 15
Node Depth : 0
Domain State : DomainController
Recovery State : None
Management VLAN
VLAN ID : 4092
Management Subnet : 172.31.0.0
Management IP Address : 172.31.0.1
Management Mask : 255.255.128.0
Domain VLAN
VLAN ID : 4091
Domain Subnet : 172.31.128.0
Domain IP Address : 172.31.128.1
Domain Mask : 255.255.128.0
Table 3: Parameter definitions from the show atmf details command
Parameter Definition
ATMF Status The Node’s AMF status, either Enabled or Disabled.
Network Name The AMF network that a particular node belongs to.
Node Name The name assigned to a particular node.
Role The role configured for this AMF device, either Master or Member.
Current ATMF Nodes The count of AMF nodes in an AMF Network.
Node Address An Address used to access a remotely located node. This is simply the Node Name plus the
dotted suffix atmf (.atmf).
Node ID A Unique identifier assigned to a Node on an AMF network.
Node Depth The number of nodes in path from this node to level of the AMF root node. It can be thought
of as the vertical depth of the AMF network from a particular node to the zero level of the AMF
root node.