Specifications

AMF Commands
New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions 195
atmf provision node delete
This command deletes files that have been created for loading onto a provisioned node. It
can only be run on master nodes.
Syntax atmf provision node <nodename> delete
Mode
Privileged Exec
Usage This command is only available on master nodes in the AMF network. The command will
only work if the provisioned node specified in the command has already been set up
(although the device itself is still yet to be installed). Otherwise, an error message is shown
when the command is run.
You may want to use the atmf provision node delete command to delete a provisioned
node that was created in error or that is no longer needed.
This command cannot be used to delete backups created by the AMF backup procedure.
In this case, use the command atmf backup delete to delete the files.
Example To delete backup files for a provisioned node named switch3 use the command:
To confirm that the backup files for provisioned node switch3 have been deleted use the
command:
The output should show that the provisioned node switch3 no longer exists in the backup
file, as shown in Figure 4:
Parameter Description
<nodename> The name of the provisioned node to be deleted.
Note
This command allows provisioned entries to be deleted even if they have been
referenced by the atmf provision command, so take care to only delete
unwanted entries.
switch1#
atmf provision node switch3 delete
switch1#
show atmf backup