Specifications

AMF Commands
New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions 193
atmf provision node create
This command sets up an empty directory on the backup media for use with a provisioned
node. This directory can have configuration and release files copied to it from existing
switches. Alternatively, the configuration files can be created by the user.
An alternative way to create a new provisioned node is with the command atmf provision
node clone.
This command can only run on amf master nodes.
Syntax atmf provision node <nodename> create
Mode Privileged Exec
Usage This command is only available on master nodes in the AMF network.
The atmf provision node create atmf command (or atmf provision node clone) must
be executed before you can use other “atmf provision node” commands with the specified
node name. If a backup or provisioned node already exists for the specified node name
then you must delete it before using this command.
A date and time is assigned to the new provisioning directory reflecting when this
command was executed. If there is a backup or provisioned node with the same name on
another AMF master then the most recent one will be used.
Example To create a new provisioned node named switch2 use the command:
Running this command will create the following directories:
■ <media>:atmf/<atmf_name>/nodes/<node>
■ <media>:atmf/<atmf_name>/nodes/<node>/flash
To confirm the new node’s settings, use the command:
The output for the show atmf backup command is shown in Figure 3, and shows details
for the new provisioned node switch2.
Parameter Description
<nodename> The name of the node that is being provisioned.
switch1#
atmf provision node switch2 create
switch1#
show atmf backup