Specifications

AMF Commands
178 New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions
To reset the AMF domain VLAN to its default of 4091, use the following commands:
atmf enable
This command manually enables (turns on) the AMF feature for the switch being
configured.
Use the no variant of this command to disable (turn off) the AMF feature on the member
node.
Syntax atmf enable
no atmf enable
Default
Once AMF is configured, the AMF feature starts automatically when the switch starts up.
Mode Global Configuration
Usage The switch does not auto negotiate AMF domain specific settings such as the Network
Name. You should therefore, configure your switch with any domain specific (non default)
settings before enabling AMF.
Examples To turn on the AMF the feature:
To turn off the AMF feature:
This command returns the following display:
VCF-1#
configure terminal
VCF-1(config)#
no atmf domain vlan
MyNode#
config terminal
MyNode(config)#
atmf enable
MyNode(config)#
no atmf enable
% Warning: The ATMF network config has been set to enable
% Save the config and restart the system for this change to take
effect.