Specifications

AMF Commands
New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions 175
atmf distribute firmware
This command can be used to upgrade software one AMF node at a time. A URL can be
selected from any media location. The latest compatible release for a node will be selected
from this location.
Several procedures are performed to ensure the upgrade will succeed. This includes
checking the current node release boots from flash. If there is enough space on flash the
software release is copied to flash on the new location.
The new release name is updated using the boot system command. The old release will
become the backup release file. If a release file exists in a remote device (such as TFTP or
HTTP, for example) then the URL should specify the exact release filename without using a
wild card character.
Supported units include x908, x8100, x610, x210 and all stack configurations.
The command will continue to upgrade software until all nodes are upgraded. At the end
of the upgrade cycle the reboot command should be used on the working-set.
Syntax atmf distribute firmware <url>
Mode
Privileged Exec
Examples To upgrade nodes in a atmf network with a predefined AMF group called sw_team, use
the following commands:
Output
Parameter Description
<url> The URL of the file. See “URL Syntax” in the “Creating and
Managing Files” chapter of your switch’s Software Reference for
valid URL syntax.
SW_Team1#
atmf working-set group sw_team
=============================
SW_Team1, SW_Team2, SW_Team3:
=============================
Working set join
ATMF_NETWORK[3]#
atmf distribute firmware card:*.rel