Specifications

AMF Introduction and Configuration
134 New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions
Here is an example output of the show arp command run from a working-set:
Invalid working-set commands
Some commands can only be executed on certain nodes within the working-set. In this
case the command will be attempted on all nodes within the working-set. For any node
for which the command is not valid, the command execution will fail and the output
displayed will indicate the nodes on which the command succeeded and nodes on which
the command failed.
Below is example output from the show card command run from a working-set, which is
only a valid command for the SBx8100 series switches.
atmf1[4]#show arp
=======
Master:
=======
IP Address MAC Address Interface Port Type
172.31.0.1 eccd.6d7d.a542 ATMF sa1 dynamic
172.31.0.3 0000.cd2b.0329 ATMF sa1 dynamic
172.31.0.10 0000.cd37.0163 ATMF sa1 dynamic
=======
x510_1:
=======
IP Address MAC Address Interface Port Type
172.31.0.2 eccd.6d03.10f9 ATMF sa4 dynamic
===========
x908_VCS_1:
===========
IP Address MAC Address Interface Port Type
172.31.0.2 0000.cd37.1050 ATMF sa1 dynamic
===========
x908_VCS_2:
===========
IP Address MAC Address Interface Port Type
172.31.0.2 0000.cd37.1050 ATMF sa3 dynamic
atmf1[4]#