Specifications

ISSU Commands
98 New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions
show boot
This command displays the current boot configuration. We recommend that the currently
running release is set as the current boot image. ISSU will not execute if there is no current
boot image.
Syntax show boot
Mode
Privileged Exec
Example To show the current boot configuration, use the command:
Output Figure 1: Example output from the show boot command with the current boot
configuration set on a USB storage device
Figure 2: Example output from the show boot command with ISSU running
Note
When running ISSU, this command will compare the software versions that are
running on each of the CFCs. Where there is a difference in versions running on
either VCStack Plus, or a standalone chassis, an asterisk is appended to the
current version. An explanation is also shown at the end of the output screen
indicating what further action can be taken.
awplus#
show boot
awplus#show boot
Boot configuration
----------------------------------------------------------------
Current software : SBx81CFC960-5.4.4-1.2.rel
Current boot image : usb:/SBx81CFC960-5.4.4-1.2.rel
Backup boot image : flash:/SBx81CFC960-5.4.4-1.1.rel
Default boot config: flash:/default.cfg
Current boot config: usb:/my.cfg (file exists)
Backup boot config: flash:/backup.cfg (file not found)
#show boot
Boot configuration
----------------------------------------------------------------
Current software : SBx81CFC960-5.4.4-1.2.rel*
Current boot image : flash:/SBx81CFC960-5.4.4-1.2.rel
Backup boot image : flash:/SBx81CFC960-5.4.4-0.1.rel
Default boot config: flash:/default.cfg
Current boot config: flash:/example.cfg (file exists)
Backup boot config : flash:/backup.cfg (file exists)
* ISSU in progress - Run "show card detail" for more information