Manual

Chapter 1: Introduction & Overview

Installation & Programming Manual

1.1: Face Panel Description

The Monitor’s operating status is indicated by the two (2) LEDs on the face panel.

RUN The green LED indicates that the card is operational.

FAULT The red LED indicates there is a card fault, or when there is a resolver

(transducer) fault.

Note: There are four typical causes for a resolver (transducer) fault:

1. Broken resolver cable

2. Improperly wired cable

3. Faulty resolver

4. Non-compatible resolver

INSIDE FACE PANEL DOOR

Plug-in connector with 16 terminals. (See wiring diagrams, Appendix B)