Specification

Apply Liquid Granite® to the surface. We
recommend one to two coats of Liquid
Granite® as needed to properly seal the
surface for a watertight system. The surface
for a watertight system. The second coat is a
cover coat. A single coat application is
possible. A trowel and brush works best
when applying Liquid Granite. Five gallons
covers 70–100 square feet.
Estimated Coverage
Standard product coverage on a
smooth surface is 100 sq. ft. per
gallon per coat (est. 10 mil). More
than one coat recommended. More
coats equal longer life. Rough
surfaces will require additional product and drying time.
Clean-Up, Storage, and Disposal
Clean tools and small spills with
water. Store unused product in
its original container, tightly
sealed and protected from
freezing. Dispose of this product
in accordance with local, state, or
federal requirements.
Application Tools
You may need one or more of the following:
With a commercial sprayer, use a .0030 reversa tip.
We recommend a 3/8 inch hose.
Be sure that surfaces are clean and dry before
the coating application. Caulk all cracks
greater than 1/8” wide with Ames’® Blue
Max® trowel grade. Install adequate drains to
drain flat roof deck type structures. Shot blast
concrete in severe situations as needed. Use
Ames’® Super Primer™ for superior adhesion
on difficult surfaces. Badly decomposed
concrete requires a prime coat of Super
Primer™ to prepare the surface. Always run a
test patch first in an inconspicuous area to
ensure that there is proper adhesion and drying,
and that the product performs to your
satisfaction. Check our website at
www.amesresearch.com for the latest updates
before proceeding with the application.
Surfaces with joi
nts, cracks, flashings, vents,
parapet wall flashings or where two unlike
surfaces come together require seam tape.
We recommend Ames’® Peel & Stick™ Seam
Tape PS250 (2 inch by 50 feet) PS450 (4 inch by
50 feet) or PS650 (6 inch by 50 feet) to provide
some additional strength and reinforcement
and to bridge wide gaps. Prime all surfaces
generously with Ames’® Super Elasto-Barrier®
prior to setting the Seam Tape in place. (See
Seam Tape label for instructions.) Apply a
liberal coat of Super Elasto-Barrier® over the
Seam Tape and allow to cure. Some surfaces
may require priming with both Ames’®
Super Primer™ and Super Elasto-Barrier®
for stronger waterproofing.
1. Surface Preparation 2. Apply Seam Tape 3. Apply Liquid Granite
1 Gal = 100 Sq. Ft.
10’
10’
Do It Yourself in Three Easy Steps
To learn more application tips visit www.amesresearch.com
Scissors or
Utility Knife
3”-4” Wide
Paint Brush
Ames Peel &
Stick Seam Tape
Low Nap Roller &
Handle
Trowel
Commercial
Airless Spray