Specification

Apply Block & Wall
®
to the surface. For a
complete application we recommend two
gallons per 100 square feet for walls, and three
to four gallons per 100 square feet for cisterns
and tanks, or as needed. Block & Wall
®
Liquid
Rubber is slightly tacky and may be topcoated
on basement walls and foundations with Block
& Wall
®
acrylic coating or Paint & Prime
®
.
Sprayer Instructions and Thinning
Thin with water up to 10% or as needed for
spraying. Use a .0030 reversa tip with a
commercial sprayer. We recommend a 3/8 inch
hose for commercial applications. Apply by
brush, roller, or texture sprayer for smaller
applications.
Estimated Coverage
Standard product coverage on a
smooth surface is 100 sq. ft. per
one gallon, per coat (est. 10 mil).
More than one coat is
recommended. More coats equal
longer life. Rough surfaces will require additional
product and drying time. Average application rate is
two gallons per 100 sq. ft. or 20 gallons per 1,000 sq. ft,
or 2 coats.
Clean-Up, Storage, and Disposal
Clean tools and small spills with
water. Store unused product in
its original container, tightly
sealed and protected from
freezing. Dispose of this product
in accordance with local, state, or
federal requirements.
Application Tools
You may need one or more of the following:
With a commercial sprayer, use a .0030 reversa tip.
We recommend a 3/8 inch hose.
Be sure that surfaces are clean and dry before
the coating application. Powerwash
thoroughly, if needed. Brush, trowel, or caulk
all cracks greater than 1/8” wide with Blue
Max® Trowel Grade coating and filler. Always
run a test patch first in an inconspicuous area.
This is to ensure that there is proper adhesion
and drying, and that the product performs to
your satisfaction. Check our website at
www.amesresearch.com for the latest
updates before proceeding with the
application. Shake or stir Block & Wall
®
Liquid
Rubber before using.
Surfaces with joints, cracks, flashings, vents,
parapet wall flashings, or where two unlike
surfaces come together, require Ames® Peel &
Stick™ Seam Tape (PS250, PS450 or PS650) to
provide some additional strength and
reinforcement. Prime all surfaces generously
with Block & Wall
®
Liquid Rubber prior to
setting the Seam Tape in place. (See Seam Tape
label for instructions.) Apply a liberal topcoat of
Block & Wall
®
Liquid Rubber or Blue Max
®
over
the Seam Tape and allow to cure.
Do It Yourself in Three Easy Steps
To learn more application tips vist www.amesresearch.com
1. Surface Preperation 2. Seam Tape & Prime 3. Application
3-4 inch wide
paint brush
Texture Sprayer
Ames Seam Tape
Commercial
Airless Sprayer
Roller and
Handle
1 Gal = 100 Sq. Ft.
10’
10’