Installation Instructions

locations, press pointed tabs through one panel from the bottom. Then bend tabs down.
Overlapping panel edges are fastened together after placement by means of self-drilling,
self-tapping screw, which are screwed through both panels and into the lap fastener on
the underside of the bottom panel. Two panels can be fastened together on the ground
for fast installation.
HANDLING & STORAGE
HANDLING
CoverLite corrugated sheet, being a tough product, requires little special handling. It
is recommended, however, that the sheets must be protected from abrasion while
handling.
TRANSPORTATION & STORAGE
While in transportation and storage, never put the panels in direct contact with cements
and paints, both of which are extremely incompatible with polycarbonate. Always
utilize thick wooden boards to isolate the panels from contact with cements and paints
while transporting or storing.
The sheets must be stored horizontally on flat surface and kept away from direct
sunlight. Original crating is not sufficient to protect panels from solar heat gain
damage. Do not stack sheets covered or uncovered in direct sunlight. S tacking may
cause the sheets to heat up and distort. Always keep stacked sheets in a well-protected
and shaded area during storage and installation. The longest sheet should be at bottom
of stack. Prevent moisture from getting between stored sheets, as this may cause
whitening.
Allow for ventilation particularly at the highest point to minimize heat build-up and
provide air circulation. Under single skin roofs of any sort and especially in cold
temperature, condensation is generally unavoidable. Good ventilation will always help
minimize condensation.
CLEANING
Polycarbonate resin and panels are not resistant to abrasion. Please clean
polycarbonate panels in accordance with guidelines provided to maintain polycarbonate
sheets for long term use.
Gently wash sheets with a clean sponge or soft cloth, using lukewarm soapy water