Specifications
System Programing
IMl66-107
Master Clear and Class Of Service Defaults
Not
on/y
does the master clear procedure return ALL programmed variables to a known
state
of
ooeration. it also clears all currently stored autodial and speed dial numbers.
Aaster Clear
l.PresslTCMDial##7466
“CONFIG.
MODE”.
qetums entire system configuration to
actory settings
and clears all stomd auto
2. Dial 90
“MASTER CLEAR
:
u?d
speed dial numbers.
3. Dial 5 1 6 8 4 to clear the entire system.
System returns to normal operation mode automatically.
system Default
l.PresslTCMDial+++#7466
“CONFIG.
MODE”.
qetums the system configuration features
2. Dial 10
“SYSTEM DEFAULT”.
0 factory settings.
3. Press #to default
system features.
System returns to configuration mode automatically..
,ine Default
l.PresslTCMDial~#7466
“CONFIG.
MODE”.
qetums the line configuration features to
2. Dial 30
“LINE DEFAULT ,,.
‘actoty settings.
3. Press # to default line features.
System returns to configuration mode automatically.
ou
can return the entire programming configuration to the factory settings using the master clear procedure or
IU
can return the individual system, line, and station class of service configurations to their factory settings using
le
system, line, and station default procedures. Keep
in mind that the operating parameters and class of service
dues effected by the factory settings
will
provide satisfactory performance in a broad range of site applications.
Station Default
l.PresslTCMDial*#7466
“CONFIG.
MODE”.
Returns the station configuration features
tc
2.
Dial 50
‘STATION DEFAULT
“.
factory settings.
3. Dial 00 to default station
ports system-wide.
-OR-
Select individual station port to be defaulted:
-
Station 10
-
57: Dial 10
-
57 or press Cl 0
-
CV.
4. Dial
+K
for next station to default.
-OR-
Dial
+k
#
for configuration mode.
Default Button Assignments
Returns the button mapping of individual
stations to its factory setting.
i.PresslTCMDial+++#7466
“CONFIG.
MODE”.
’
2. Dial 56.
‘BUlTON’MAPPING
*
3. Dial
01.
BU7TON
DEFAULT
’
4. Select station ports to be defaulted:
-
Station 10
-
57: Dial 10
-
57.
5. Dial
+#
for next button mapping feature.
-OR-
Dial
f
+#
for configuration mode.
Toll Restriction
TabkDefault
The system defaults two toll restriction
tables with preprogrammed values and
assigns them to the lines. You need only tc
assign them to the stations to put them into
effect. The preprogrammed values are as
1. Dial 70.
2. Press #to default toll tables.
3. Dial
+++
for configuration mode
“DEFAULT TOLL
*
Entry
l=
1800
Entt$2
=
976
Entt$2=911
Entry3=411
These values will provide satisfactory
system performance in a broad range of
site applications; however, they can be
changed as needed to meet different toll
restriction needs.
Press SPKR to end.
I
4-4