Specifications

IM166-107 System Programming
Class Of Service Programming
Class of service programming provides you with the means for programming all of the system variables; however,
you may elect to program only the line attributes and leave the remainder of the system variables set to their
default values. Perform the class of service programming in the sequence shown below.
Automatic Hold
\
When you enable this feature, the
telephone user can automatically
existing line call on hold when she or he
presses another line button to
second call.
Automatic Hold For Intercom
Enter the base level programming mode.
Mark the desired selections in the
charts to record programming needs.
Typical Feature Programming Sequence
- To enable automatic hold for line calls,
1. Dial 53.
?3TATlON FEA
2. Dial 11.
‘AUTO HOLD
3. Select station ports (LED On = Feature Asssigned):
- Station 10 - 57: Dial 10 - 57 or press Cl0 - C57.
4. Dial #+ for next station feature.
-OR-
Dial ++ % for configuration mode.
To change setting, repeat procedure and make opposite selection.
To enable automatic hold for intercom calls,
1. Dial 53.
“STATION FEA TlJRES”
2. Dial 12. STCM AUTO HOLD”
3. Select station ports (LED On = Feature Assigned):
- Station 10 - 57: Dial 10 - 57 or press Cl 0 - C57.
ake opposite selection.
a Dial a feature code to select a programming
parameter.
A current program setting is indicated by a lighted
LED next to the applicable programming button.
When a toggle (ON/OFF) action is provided by a
single button, the lighted LED indicates when the
feature is active.
If a tone burst sounds three times during
programming, it denotes an erronous input.
Programming can be continued after an error
without ending and re-entering the programming
mode from base level..
10 Press % to return to the most previous
programming level. Each press returns to the
next previous programming level.
Press SPKR to end procedure.
4-3