Specifications
IMl66-107 System Programming
Toll Restriction Configuration
-
continued
Assign Toll Restriction Override
(TRO)
You can use the sequence of steps listed below to program a TRO
Code:
The TRO feature allows users to code from station 10.
override the toll restriction that they 1. Press
ITCM
and dial
+K
# 7 4 6
+++
to enter COS
encounter at other stations with their own programming,
“CONFIG.
MODE”
station’s toll restriction assignments. In
2. Dial
53 for station features,
“STATION FEATURES”
programming for this feature, create a
3. Dial 25 for toll restriction override codes, “TOLL R. OVERRIDE”
four-digit TRO code that users can dial to
override the toll restrictions of any station NOTE:
If
you are programming with a
DSSBLF
console, notice
that they happen to be using and replace it
that it’s status LEDs turn on to indicate stations that have
with a toll restriction that matches their
an assigned TRO code (Cl0
-
C57 = station ports 10
-
57).
home station.
NOTE:
The system marks outgoing
4. Select station port (LED flashes = selected stafion port,
line calls that use/s make after
display shows TRO if assigned.),
entering a TRO code with a
(r)
i
-station
10
-
57 = dial
10
-
57
or press Cl 0
-
C57
n its
SMDWSMDA
pyintouts.
The station number that it prints
5. Type four-digit TRO code,
“NNNN
”
is that of the overriding station
and not the actual station that
the call was made from.
6. Repeat steps 4 and 5 for next station port,
7. Dial
G+G
for configuration mode
-OR-
press
SPEAKER
to end,
8. To remove a TRO code, repeat steps 1 through 3,
select station port, type # and press
SPEAKER
You can use the sequence of steps listed below to program a TRO
code using your VDT.
1. Type
I
%
7 4 6
+k
and press RETURN to enter COS
programming
2. Type 3 and press
RETURN
for station COS menu,
3. Type 8 and press
RETURN
for
toll
menu,
4. Type 4 and
RETURN
to choose
toll
overt-i& feature,
. .
5. Type
1
and
RETURN
to choose
a%ig~
toll
re&xWn
overrick
codes
item,
6. Type station port number
(10
-
57) and press
RETURN,
7. Type four-digit toll restriction override code and press
RETURN,
8. Press and hold
CTRL
and type C to return to main menu.
You can remove a TRO code from a station port by following a
similar procedure.
1. Repeat above steps 2 through 4,
. .
2. Type 2 and
RETURN
to choose
B
override
item,
3. Type station port number
(10
-
57) and press RETURN,
4. Press and hold
CTRL
and type C to return to main menu
4-76A
(TAB1 17~5)