Specifications
IMi66-107
System Programming
Toll Restriction Table Configuration
-
continued
0
To make the programming selections, dial the feature code and then dial the configuration code (or press the
programming button where appropriate).
NOTE: A lighted LED next to the programming button for the selection indicates the current configuration.
When a sing/e button provides a toggle (on/off) action, the lighted LED indicates the active feature.
0
The first step in any programming sequence is to enter the base level. Once in this mode, you can dial the
feature code for any desired configuration. Enter the base level with the following procedure: press
ITCM
then
dial
++F#
7 4 6
G#C.
The last step is to press the
SPKR
button to end the programming procedure and return the
system to normal operation.
0
You can return the toll table values to the default state by entering base level, dialing 70#, and pressing
SPKR.
/
Press
ITCM
+##746&
1
Assign
Entries To Toll Restriction Tables
Assign Toll Restriction Tables To Lines
1. Dial 71.
“TOLL TABLE
”
2. Dial
01
-
16
or Press Al
-
A14,
Bl,
B2
for toll table 1
-
16.
“XxXxX
TABLE
Y
’
3. Dial 5 or Press
Al
to establish an allow toll table.
(Al LED on = allow)
‘ALLOW TABLE Y
’
-OR-
Dial 6 or Press A2 to establish a deny toll table.
(A2 LED on = deny)
‘DENY TABLE Y
y
4. Dial
1
-
4
or Press
A8, A9, AlO, All
for entry
number
1
-
4.
“xxxxxx
*
5. Dial # to clear current entry.
Y
6. Dial keypad digits (0
-
9, #) to enter numbers.
“Xx-xXxX...
I4
7. Dial
+I+
for next entry and repeat steps 4
-
6 until
all table restrictions are entered.
8. Dial
+I+
+I+
for next table and repeat steps 2
-
7
until all tables are entered.
9. Dial
+K
t
+#
for configuration mode.
To change setting, repeat procedure and make different selection.
1. Dial 72. “ASSIGN TOLL-LINE”
2. .Dial 01
-
16 or Press
Al
-
A14,
Bl,
82
for toll table 1
-
16.
3. Dial # to finish entry and display lines.
4. Select line ports (LED On = Lines selected to receive tables).
-
Line port 1-16 = Dial
01
-
14
or Press
Al
-
A14.
-
Line port
1516
= Dial
15,16
or Press
Bl,
B2
-
Line port 17-24 = Dial
17-24
or press
HOLD
then dial
Al
-
A8
5. Dial
*
and repeat steps 2-4 for next toll table to line assignment.
-OR-
Dial
*
++
for configuration mode.
To change setting, repeat procedure and make different selection.
4-75