Specifications

System Programming IMl66-107
Toll Restriction Table Configuration
Before programming the toll restriction configuration, enter the toll restriction requirements on the toll restriction
reference tables found at the end of Chapter 4.
In order for toll restriction to take effect, the following three-fold process must occur.
B Program entries in one or more toll tables
D Assign toll tables to all appropriate lines.
D Assign toll tables to all appropriate stations.
After you program the toll tables, you must assign them to both a line and the station that uses that line before
the system will activate any programmed toll restriction at the station.
1. Determine the types of dialing restrictions that you wish imposed on the system. Typically, this includes
access codes which result in toll charges, and certain local numbers as desired.
2. If you wish the restricted dialing codes to be imposed consistently on most or all stations in the system, list
them on one or two tables.
If you must allow for a wide variation in the dialing restrictions, spread the listing
out across several tables.
3. Strategically group the listings on the tables so that a list of restrictions can be applied to a particular station or
group of stations.
4. Designate each table as a DENY table or as an ALLOW table. The system prevents the dialing of numbers
entered in a DENY table. ALLOW tables take precedence over DENY tables. Therefore, an entry in an allow
table will provide an explicit exception to an entry in a DENY table. Note that the system always permits the
dialing of any number not explicitly denied. Also, note that the system will not toll restrict system speed dial
numbers unless you specify them to be restricted with a separate programming step.
Example A: Provide a simple and broad toll restriction format by creating a DENY table with two entries:
ENTRY (1) = 1; ENTRY (2) = 0. This format prevents all long distance and Operator Calls.
Example 6:
Prevent the dialing of all numbers within the (804) area code, while allowing the dialing of one
specific number within that area code. by entering 1604 in a DENY table and 18049782200 in an ALLOW
table.
8. Press the # button in place of a particular digit to condense a range of numbers into one entry. The #
character is a “match-anything” digit, and can be included in an entry in either a DENY table or an ALLOW
table.
Example A: If 357,377, 387, and 397 dialing is to be prohibited, list one entry of 3#7 on a DENY table to
cover them all.
Example B: Since area codes typically have a 1 or a 0 as a middle digit, prevent long distance calls to those
area codes by entering l#l# and l#O# in an DENY table.
6. Since it is important that emergency numbers never be restricted, always create an allow table with entries of
91’1 and 1911 to override any DENY tables that you havecreated.
7. If the system is installed behind a PBX, include an access code as part of every table entry.
8. The system defaults two toll restriction tables with preprogrammed values and assigns them to the lines. You
need only to assign them the stations to put them into effect. The preprogrammed values are as follows:
Entry 1 = 1
Entry 2 = 976 Entry2=911
Entry3=411
These Values will provide satisfactory system performance in a broad range of site applications; however, the!
can be changed as needed to meet different toll restriction needs.
I
continued on next page. . .
4-74